Machsupport Forum
Mach Discussion => General Mach Discussion => Topic started by: Rogeman on June 06, 2011, 09:56:06 AM
-
I have just down loaded and installed R3.043.022 on win 7 32 bit. I use TurboCAD15 Cad/Cam.
I only use this system to create the original files but use XP on the actual machine output.
The arc locations now seem to be in the wrong place,the linear postions are Ok.
See attached file.The first file I used was more complicated so drew anothersimple one to prove the point with the same result.
Does anyone have any suggestions please.
Regards
Roger
The second picture is what I expected it to be.
-
Hi,
Dredging my memory I had a similar problem a while ago.
I cured it by changing my cam settings to output arcs in max 90 degree section.
ATB
Derek
-
Hi Derek,
Thanks for you reply, I am not sure how to achieve that with Turbocad/cam.
As I said it only occured when I updated to the latest Mach3, it was Ok with Ver. 2.6
I have run the same file on 2.6 no problems.
Regards
Roger