need help z axis how will engraving down

[kocher]

 hi iam newbie please i have funny problem after load gcode i press start my z axis should engraving into wood i gose oppisiet it go up ? how it will engraiving down not up  can anyone explain please? 

[Hood]

If you press the PgUp button does the axis go up and does the Z DRO go in a positive direction?
Hood

[kocher]

sorry for delay, when i press pageup and page down nothing happening , idid set up my key board direction of axiss for z axis  is A for  UP and  D for DOWN  its working axis go up and  down by A AND d my gcode is GO Z1.0000  and on mach3 page XYZ4 ALL +0.00000 WEN I PUT gcode  the z go down , and when it start engraving it slowly engraving up that all thanks fro you help,

[Hood]

Ok so if you are at Zero in the Z and you command a move to Z1 it goes down? If that is correct then you need to reverse your axis as Z1 should be up and Z-1 would be down. To change the direction go to Config menu then Homing and Limits page and then reverse for the Z axis.
Hood

[kocher]

thank you very much its done now thanks for  your help

[Hood]