Hello Guest it is April 19, 2024, 09:05:49 AM
Profile Guest
« previous next »
Pages: 1   Go Down

Author Topic: PDS Columbo 90rv tool changer setup  (Read 3163 times)

0 Members and 1 Guest are viewing this topic.

Offline HomeMadeCnc

*
  • 5 5
    • View Profile
PDS Columbo 90rv tool changer setup
« on: February 04, 2009, 08:31:09 PM »
Hello All,
I'm in the middle of building a 5x10 4 axis Mechmate. I have a PDS Columbo 90rv that will be installed. Does anyone have any experance in setting up the tool changer and the rack (or for that matter the spindle too!)? I'm about a month away from its setup so its time to start detailed planning for it.
Thanks for your time,
Tim
Logged
Its all BS until its built!

Offline Chaoticone

*
  • *
  • 5,624 5,624
  • Precision Chaos
    • View Profile
Re: PDS Columbo 90rv tool changer setup
« Reply #1 on: February 04, 2009, 10:50:26 PM »
Looking good Tim.  :o

Post your questions on the tool changer in the General Mach discussion board. There have been many tool changers of all types set up and I'm thinking this is one of the simplest. Give more detail on it in your post too.

Brett
Logged
;D If you could see the things I have in my head, you would be laughing too. ;D

My guard dog is not what you need to worry about!

Offline fer_mayrl

*
  • *
  • 453 453
    • View Profile
Re: PDS Columbo 90rv tool changer setup
« Reply #2 on: February 05, 2009, 11:31:29 AM »
Hey Tim,
Is that the spindle version that you need to add an external fan for cooling?

How much did it cost? I have emailed colombo but have not gotten a reply.

Your machine will be a good powerhorse!
Best Regards
Fernando
Logged
Pages: 1   Go Up
« previous next »