Hi All
I am looking for help getting the tool change to work on my lathe. I have a tool turret but it has to be programmed to a linear position to make it rotate.. ( Won't use degrees) I can make it rotate to a specified position but I can't get the tool offsets to work. Here is a code I wrote to position the tool tip at a specified point.
( THIS PART sets up tool 1 and tool 3)
G0 x3 z6
G0 A0 (rotate tool turret to pos 1)
T1 (Load tool 1)
G43 H1 (load tool 1 offsets all set to 0)
G0 x2 z0 (Touch corner of setup stock)
G0 x3 z4 ( Move Away from stock)
G0 A-7.2 (Rotate tool turret to tool 3)
T3 (Change to tool 3)
G43 H3 (Load tool 3 offsets)
G0 x2 z0 (Touch corner of tool to setup stock)
M3
Screen shots of the tool table and the tool setup screens are attached.
Thanks
Rick