Hello Guest it is March 28, 2024, 06:16:38 PM

Author Topic: Cannot do single point threading. What's wrong?  (Read 7641 times)

0 Members and 1 Guest are viewing this topic.

Offline Hood

*
  •  25,835 25,835
  • Carnoustie, Scotland
    • View Profile
Re: Cannot do single point threading. What's wrong?
« Reply #10 on: November 11, 2008, 03:34:15 PM »

as it turns out I'm the one who has no idea what I'm talking about.
Joe

Now your talking Joe, you are now a fully paid up member here welcome to the club :)

Hood

Offline simpson36

*
  •  1,369 1,369
    • View Profile
Re: Cannot do single point threading. What's wrong?
« Reply #11 on: November 11, 2008, 03:44:15 PM »
Joe,

Well, I see my use of the secret code word 'slot' successfully confused everyone . .LOL!!

I don't know what to call it, Joe and in my case it is actually a round hole in the disk,  . . . . BUT . . . , the Mach manual calls it a 'slot' so I assumed that was the convention.

 . . "When in Machville . . . ."

Interesting discussion, thanks all.