Hello Guest it is March 29, 2024, 02:14:08 AM

Author Topic: 2 motors driving x axis on router  (Read 3076 times)

0 Members and 1 Guest are viewing this topic.

2 motors driving x axis on router
« on: July 01, 2006, 05:33:45 PM »
I have 2 motors driving the x axis and they have a seperate plug each into the controller. what do i need to do to get them running in sync. Do I set up a new axis, say the A axis? or should they both be driven from the x axis setup? I dont want 1 motor to move on its own and pull the router gantry accross!! ???
Re: 2 motors driving x axis on router
« Reply #1 on: July 01, 2006, 09:27:11 PM »
under Config there is a place to slave an axis...
Fixing problems one post at a time ;)

www.newfangledsolutions.com
www.machsupport.com