Hello Guest it is April 16, 2021, 07:46:02 AM

Author Topic: Cutter marking wood  (Read 3223 times)

0 Members and 1 Guest are viewing this topic.

Cutter marking wood
« on: July 01, 2006, 03:47:16 PM »
Hi all.

I have a small problem whilst cutting Mach3 does not appear to be reading the program too well I think, My cutter is cutting in a  jerky  motion, can anyone tell me what the problem is.

Thanks Bill S
Re: Cutter marking wood
« Reply #1 on: July 01, 2006, 09:26:13 PM »
What are your steps per unit and could we have a pic of the mill :)
Fixing problems one post at a time ;)

www.newfangledsolutions.com
www.machsupport.com
Re: Cutter marking wood
« Reply #2 on: July 02, 2006, 02:04:36 PM »
Thanks Brian,

One of the problems is solved and I think I know what the other is, first one was not cutting smooth, that was caused by me having the CV FEEDRATE button check at + 10, as soon as I turned it off bingo smooth and faster cuts, Second is the marking on the wood, I have 12mm bars carrying my zaxis and there is a slight amount of flexing so, I think I will go and get some 18/19 mm bars and do a re-build in that area, not all the marking has gone but it is a lot better.

Kind Regards

Bill