Hello Guest it is March 28, 2024, 03:35:42 PM

Author Topic: backlash  (Read 3547 times)

0 Members and 1 Guest are viewing this topic.

backlash
« on: June 18, 2006, 10:27:59 AM »
Hai All,
I am setting up a router with a servo drive.
The problem i am facing is that the gearbox of the servo motor is having a backlash of 2degrees on the gear end.
I want to use the gear box and do not plan to use a timing belt.
So I plan to install the encoder to the shaft of the gear box and not the motor spindle.
Will this cause any unnecessary hunting of the system.
I plan to use a higher count encoder so that accuracy is not compromised

Regards,
Antony.
 
Re: backlash
« Reply #1 on: June 18, 2006, 11:41:19 AM »
You have to put the encoder on the motor. There is no way around it...
Fixing problems one post at a time ;)

www.newfangledsolutions.com
www.machsupport.com

ynneb

*
Re: backlash
« Reply #2 on: June 18, 2006, 07:33:47 PM »
Quote
I plan to use a higher count encoder so that accuracy is not compromised
You have already introduced a serios comprimise, by using that gearbox.

One thing I have learnt about CNC is that you can have 90% good parts, but that 10% in bad parts, makes a 100% bad machine.