Hello Guest it is November 22, 2019, 06:36:17 PM

Author Topic: Gecko 340 Fault Light  (Read 1931 times)

0 Members and 1 Guest are viewing this topic.

Gecko 340 Fault Light
« on: September 28, 2008, 12:48:25 PM »
Hi All

I have finally got round to wiring up my gecko drives. When I power up the system the fault light on the Gecko Drive will not go out. I have Err/Reset & ENC+ wired via a reset switch.

Should the system be grounded or earthed.

Does anyone have any ideas about what is wrong

Regards

Flash
« Last Edit: September 28, 2008, 01:50:28 PM by Flash Gordon »
Re: Gecko 340 Fault Light
« Reply #1 on: September 28, 2008, 02:47:25 PM »
I have found the problem. The reset switch has to be held in for atleast 3 seconds