Hello Guest it is December 14, 2019, 07:20:19 PM

Author Topic: Z (knee) didn't retract???  (Read 4107 times)

0 Members and 1 Guest are viewing this topic.

Re: Z (knee) didn't retract???
« Reply #10 on: September 25, 2008, 12:58:58 PM »
I THINK it MAY have been because of the 2in tool change??

Offline Hood

*
  •  25,856 25,856
  • Carnoustie, Scotland
    • View Profile
Re: Z (knee) didn't retract???
« Reply #11 on: September 25, 2008, 04:15:28 PM »
Sorry forgotto test it out on the mill. Have you got it sorted?

Hood
Re: Z (knee) didn't retract???
« Reply #12 on: September 25, 2008, 04:18:13 PM »
no prob. well, I redid the code without the tool change and it retracted. can't upgrade anything cause it's all current.