Hello Guest it is March 28, 2024, 04:50:02 PM

Author Topic: Delta ASD-B servo pulse problem (please help)  (Read 4385 times)

0 Members and 1 Guest are viewing this topic.

Delta ASD-B servo pulse problem (please help)
« on: September 25, 2008, 10:05:36 AM »
Helloo,

I have very big problem.I have 400 watt delta ac servo .I setup my system 1000 pulse for 1 mm and when I write G0 X+1 then G0 X0 .The servo dont get back start position.The servo company said that the mach3 not produce same pulse count.And I looked the servo online watch system when I said go +1 mm  produce 982 pulse then go the 0 (start point) it produce 943 pulse so 39 pulse miisng?

What is the problem? Ground problem or what? I am using shermil 1/2.I have direct parallel interface card for direction and step

Please give me advice

Offline Hood

*
  •  25,835 25,835
  • Carnoustie, Scotland
    • View Profile
Re: Delta ASD-B servo pulse problem (please help)
« Reply #1 on: September 25, 2008, 04:06:21 PM »
Mach will be sending the correct pulses but possibly your drives are not seeing them, try increasing the pulse width.
Hood
Re: Delta ASD-B servo pulse problem (please help)
« Reply #2 on: September 26, 2008, 06:20:22 AM »
I tried it.But there is still problem. I made it 5 10 15 but there is no difference
Re: Delta ASD-B servo pulse problem (please help)
« Reply #3 on: October 01, 2008, 07:43:58 AM »
......................as ASD-B has NPN input for pulse n dir input n i guess its 24vdc..............make sure coz i've used it with the PLC n it does well.

Kindly use some high speed isolator card for 5vdc (lpt port) and 24vdc (drive side) power isolation .