Hello Guest it is December 15, 2019, 12:46:03 PM

Author Topic: Jog capabilities lacking in Mach3?  (Read 2123 times)

0 Members and 1 Guest are viewing this topic.

Jog capabilities lacking in Mach3?
« on: September 19, 2008, 09:00:15 AM »
I got my recently purchased retrofitted mill, which was delivered with Mach2, to run on Mach3. I cannot find a way to jog in steps within Mach3 like you could in Mach2. The continuous jog works fine via the arrow keys and page up/page down. How do I jog in increments like you could on the manual tab in Mach2 (other than MDI mode running single lines of G code)?
Joe
Re: Jog capabilities lacking in Mach3?
« Reply #1 on: September 19, 2008, 09:02:58 AM »
Nevermind, I was just reading the manual. Found the tab function. Guess I better read the whole manual lest I end up looking like MORE of a fool.
Joe