Hello Guest it is December 10, 2019, 05:00:18 AM

Author Topic: can not calibrate axis  (Read 4621 times)

0 Members and 1 Guest are viewing this topic.

Re: can not calibrate axis
« Reply #10 on: September 06, 2008, 07:40:19 AM »
thanks, i am going to change my breakout board and see what happens i have a g100 i bought when they first came out and never hooked it up the cnc4pc was easyer for me because there was more how to doc. it is on all axis just my y was the first that i noticed was not correct. i had a servo on my y axis when ii first noticed it i with steppers on the other 2 and thought it was just it because when i checked my axis and set them it was one inch  and everything checked out. till i went to start a project and my y axis over shot my work. i checked others at one inch and it was okay but when i checked other lenths on my x it was not okay. i did driver test again and it looks good.
Re: can not calibrate axis
« Reply #11 on: September 08, 2008, 07:10:12 PM »
thank i got it going good today i cut two parts today and they were within .001" what i needed i changed my cnc4pc braekout board to a g100 i had. i guess it was just a bad new board. thanks ben

Offline Hood

*
  •  25,856 25,856
  • Carnoustie, Scotland
    • View Profile
Re: can not calibrate axis
« Reply #12 on: September 08, 2008, 07:22:10 PM »
glad that you are sorted :)
Hood