Hello Guest it is April 18, 2024, 08:08:44 PM
Profile Guest
« previous next »
Pages: « 1 2 3   Go Down

Author Topic: dual x axis direct drive jumpy  (Read 12719 times)

0 Members and 1 Guest are viewing this topic.

Offline Dzackman

*
  • 7 7
    • View Profile
Re: dual x axis direct drive jumpy
« Reply #20 on: August 28, 2008, 12:58:41 PM »
   I to am having the same jumpy problem at low speeds with my X axis using the 4 axis Mechatronics board.
I switched from a Xylotex 4 axis board that ran fine until a lack of proper grounding on my plasma cutter messed it up some how.
The Mechatronics board has a lot of good features so I’m hoping some how we can figure this out. I look forward to watching this forum post

Dzackman
Logged

Offline Dzackman

*
  • 7 7
    • View Profile
Re: dual x axis direct drive jumpy
« Reply #21 on: August 29, 2008, 06:39:07 AM »
Solved my problem, it was a loose wire. For anyone else with the motor jitters at low speed, check and check again your wiring.

Dzackman
Logged
Pages: « 1 2 3   Go Up
« previous next »