Arrow to arrow is the x axis

I would try to eliminate as much backlash as possible by mechanical means. Sounds like you have about .022 to me and that is quite a bit.    Even with backlash comp. set up, a tool can pull and push the work. You could go into Config, backlash and set the values for each axis there. I would try starting with a backlash speed of 200% and then go to Config., General config, center top and set shuttle accel to .05 seconds.

Let us know how this does,
Brett 

replaced the leadscrew nut for that axis and now i have backlash programmed for .006 and that solved the problem

Good deal. Glad you got sorted. 

Brett