Hello Guest it is October 17, 2021, 06:29:20 PM

Author Topic: Dyna Myte dm3000 conversion  (Read 3670 times)

0 Members and 1 Guest are viewing this topic.

Dyna Myte dm3000 conversion
« on: January 16, 2008, 09:50:21 AM »
I know a few people have done these. There was one on ebay not to long ago that mentioned the folks from mach3 gave him the toolchange macro for the lathe. Any help?

I am in a dilema, I have the lathe, and it has most of the boards, but none of them are wired up. My original intentions were to just use the original drives and a campbell breakout board that I have on hand. That went out when I found out nothing was hooked up. Anybody know what kind of performance I would get hooking it up to say a xylotex setup? My other option is gut it and use some pittmans and geckos.

How do I control the spindle motor on this lathe, should I scrap it as well? Anybody ever got its spindle encoder working with any of these drives/mach3?

Thanks for any help.


Re: Dyna Myte dm3000 conversion
« Reply #1 on: August 09, 2008, 10:37:24 PM »
Have you had any replies or help yet?