Hello Guest it is April 24, 2024, 06:38:57 AM
Profile Guest
« previous next »
Pages: « 1 2 3   Go Down

Author Topic: z after running file  (Read 10295 times)

0 Members and 1 Guest are viewing this topic.

Offline Beams

*
  • 9 9
    • View Profile
Re: z after running file
« Reply #20 on: October 02, 2007, 10:34:09 PM »
No Problem on my part. I should have read that section better. I downloaded 2.52. Initial testing shows the problem to be gone.


Mark
Logged

Offline Kent McVicker

*
  • 10 10
    • View Profile
Re: z after running file
« Reply #21 on: June 24, 2008, 08:26:42 PM »
I'm up to ver. 2.63 and z still doesn't return to the proper position after completing cutting a file when I use auto tool zero.

Kent 
« Last Edit: June 24, 2008, 08:28:23 PM by Kent McVicker »
Logged
Pages: « 1 2 3   Go Up
« previous next »