Hello
Guest
it is
February 07, 2025, 05:37:44 AM
Guest
Login
Register
Menu
Home
Help
Search
Login
Register
YouTube
Machsupport Forum
/
Mach Discussion
/
General Mach Discussion
/
How to change Reverse speed?
« previous
next »
Print
Pages:
1
Go Down
Author
Topic: How to change Reverse speed? (Read 7337 times)
0 Members and 1 Guest are viewing this topic.
giannis121
145
How to change Reverse speed?
«
on:
June 13, 2008, 08:21:39 AM »
How can i change the reverse speed?
I tried changing the FeedRate OEMDRO(818) to a very low value,
but everytime i hit the reverse button OEMButton(279), goes back very fast.
Any ideas?
Logged
Hood
25,835
Carnoustie, Scotland
Re: How to change Reverse speed?
«
Reply #1 on:
June 13, 2008, 11:21:59 AM »
Are you not using the FRO slider? That is the way to slow down the code, typing a number into the DRO will be overwritten by the speed in the code. Maybe I am misunderstanding what you are meaning?
Hood
Logged
giannis121
145
Re: How to change Reverse speed?
«
Reply #2 on:
June 13, 2008, 02:11:17 PM »
No, i am not using the slider. I am using a button that says SetOemDro(818,200),
but although the feed rate DRO shows 200, the reverse speed is still high speed.
Any ideas?
Logged
Hood
25,835
Carnoustie, Scotland
Re: How to change Reverse speed?
«
Reply #3 on:
June 13, 2008, 02:16:39 PM »
Afraid not, in fact I have never used reverse run but decided to try it today to see what happened. I did the reverse run and it went at the same speed as forward. I put the FRO slider down and again reversed and again it was at the same speed. I have not tried setting the DRO from VB so cant say what would hapen in a reverse run situation and I am now home so cant test it out. If I remember tomorrow when I get to the workshop I will give it a try.
Hood
Logged
Print
Pages:
1
Go Up
« previous
next »