Hi Guys...
Question about Sherline... I have a Sherline, but with a third party stepper motor system (Low cost CNC retrofit) I have the machine set up and dialed in with a dial indicator for distances, however when I run a program, the x axis is not accurate in running the program. the x axis drifts allot..... Should I use the Sherline pulse setting to correct this drift??? I have checked the mechanical, they are fine, and the travel is dead on when I jog in .100" steps.. Even the backlash is set dead on when using the dial indicator.. Any suggestions?? I'm running X axis at 10 IPM is that too high??
Help...
Lucas