Hello Guest it is March 28, 2024, 09:30:06 PM

Author Topic: Question around operation and parameters  (Read 6430 times)

0 Members and 1 Guest are viewing this topic.

Offline jimpinder

*
  •  1,232 1,232
  • Wakefield, West Yorks, UK
    • View Profile
Re: Question around operation and parameters
« Reply #10 on: March 04, 2008, 02:30:20 PM »
My list shows that  "SetCurrentTool"(Tool  as byte) is a subroutine, not a function.

Not me driving the engine - I'm better looking.
Re: Question around operation and parameters
« Reply #11 on: March 05, 2008, 10:01:55 AM »
Got it...  I changed the lines to "call SetCurrentTool(x)" and it's working fine.

Can you tell me where I can get the "list" of calls and functions?  I looked all over the MachCustomizeWiki and did not see it?
   Thanks for the help.

Offline jimpinder

*
  •  1,232 1,232
  • Wakefield, West Yorks, UK
    • View Profile
Re: Question around operation and parameters
« Reply #12 on: March 05, 2008, 01:23:09 PM »
I think it is a Wiki attached to this forum -
it is at
« Last Edit: March 05, 2008, 01:26:15 PM by jimpinder »
Not me driving the engine - I'm better looking.