I have just configured my machine to use auto tool zero, and the system works fine if i connect a switch to the assigned pin and grounds it, but as soon as i connect the cable going from my cabinet to the junction box there must be some interference that gives a signal to the pin, cause it stops the feed and retracts as it was to hit the touch plate.
I hvae tried to increase the debounce up to 5000 but no difference.
Another thing that happened is that I have a button on my control panel for homing, and a couple of times after i have tried the zeroing using the button directly on my printercable, is that it suddenly starts homing....
I disabled this pin input and it didn´t happen again.
The funny thing is that even if only the cable is connected and not the touch plate it still gets the signal (noise)rather imideately
Anyone care to guess?
Best reg
Cory