Hello Guest it is August 03, 2020, 06:12:35 AM

Author Topic: Where did my Z axis control go?  (Read 2086 times)

0 Members and 1 Guest are viewing this topic.

Where did my Z axis control go?
« on: February 01, 2008, 08:24:29 AM »
Hi guys.
Sorry it's in Mach 2 and I promise to upgrade fast, but can I just get 2 running again?
 -Hard disc crash. Backup failed to install this time, but license ok and .xml ok, so all is up and running on new disc ,from a different copy of Mach 2, motors running sweet, x and y responding correctly.. but previously on my 'manual' screen I had an x and y 'trackball' and a z 'trackball' control. Now It's just the x and y.
I guess there's a file I need to copy over, but I can't see which one.

Who can remember that far back?

Thanks in advance

Jim
Re: Where did my Z axis control go?
« Reply #1 on: February 01, 2008, 09:08:27 AM »
No you fool, It's your screen sets under 'view'.

Jim