Hello Guest it is September 21, 2019, 12:15:29 PM

Author Topic: Is anyone else using E1P1 / E1P0 to switch output #1 ?  (Read 12900 times)

0 Members and 1 Guest are viewing this topic.

Offline BR549

*
  •  6,898 6,898
    • View Profile
Re: Is anyone else using E1P1 / E1P0 to switch output #1 ?
« Reply #30 on: July 05, 2010, 12:48:56 PM »
HUM that is interesting. Art stated early on that the E1p0/1 was to be ONLY Used on a line by itself. If used on mixed line it would error out as bad code syntax error.

Offline BR549

*
  •  6,898 6,898
    • View Profile
Re: Is anyone else using E1P1 / E1P0 to switch output #1 ?
« Reply #31 on: July 08, 2010, 08:35:15 PM »
TWEEKIE, Question on the E1p0(;-)   How are you generating your Gcode for laser???

Offline Tweakie.CNC

*
  • *
  •  7,911 7,911
  • Super Kitty
    • View Profile
    • Tweakie.CNC
Re: Is anyone else using E1P1 / E1P0 to switch output #1 ?
« Reply #32 on: July 09, 2010, 01:30:18 AM »
The example I have been using was created using a Roland engraving program which outputs HPGL, this was then converted to GCode. Then I edit the Z moves to the E1P0....

Tweakie.
Success consists of going from failure to failure without loss of enthusiasm.  Winston Churchill.

Offline BR549

*
  •  6,898 6,898
    • View Profile
Re: Is anyone else using E1P1 / E1P0 to switch output #1 ?
« Reply #33 on: July 09, 2010, 05:38:40 PM »
OK Thanks, I found a slight M5 delay in sheetcam gcode output and was wondering if you were useing that.