Hello Guest it is September 20, 2019, 06:44:02 AM

Author Topic: USB Problems  (Read 2018 times)

0 Members and 1 Guest are viewing this topic.

USB Problems
« on: January 22, 2008, 05:27:59 AM »
Hi another problem related to using the video window with a webcam

I use a shuttle pro two for jogging and it worked well until i started using the video window.

There now seem to be a delay in the execution of commands

IE i let go of the jog button but it continued to jog luckily, there wasn't an accident

The motherboard is usb 1.1 would a USB 2 pci card help matters

Phil
The Good Thing About Mach3, Is It's very Configurable

The Bad Thing About Mach3, Is It's Too Configurable

Offline jimpinder

*
  •  1,233 1,233
  • Wakefield, West Yorks, UK
    • View Profile
Re: USB Problems
« Reply #1 on: January 22, 2008, 06:29:44 AM »
Phil - I run Mach 3 through a lap-top - Toshiba, about 5 years old with USB 1. I use the standard LPT1 port to run the lathe/miller. I have never had any problems, it runs the system superbly, and being a laptop, sits on a shelf out of the way.

I got a web camera for Christmas - and plugged it in. I got a picture through windows, I couldn't get a picture through the video window on Mach 3, the system started running slowly, it told me I had a fast (series 2) USB device in a slow USB slot, and finally the whole lap-top crashed, I lost the screen picture etc etc. The memory seemed to get over written.

I gave up with the Web Cam and all is back to normal.

Not me driving the engine - I'm better looking.