Hello Guest it is April 16, 2021, 04:24:09 AM

Author Topic: Not ignoring tool change  (Read 1964 times)

0 Members and 1 Guest are viewing this topic.

Not ignoring tool change
« on: January 12, 2008, 08:20:41 PM »
After upgrading to version 3.00 when I get to this line N40t1m06 Mach waits for me to press cycle start again before continuing.  I have ignore tool change selected in configuration.  This is the same file that I ran in the previous version without this problem.  Any ideas what is causing this?

Re: Not ignoring tool change
« Reply #1 on: January 12, 2008, 09:32:12 PM »
Hey George,
Hood helped me with a similar problem some time back.
We set mine like below and it cycled right through.
Try it in air first.