Hello Guest it is September 27, 2023, 12:33:39 AM

Author Topic: Griffin PowerMate  (Read 2817 times)

0 Members and 1 Guest are viewing this topic.

Griffin PowerMate
« on: December 30, 2007, 09:24:12 PM »
I just purchased one of the Griffin PowerMates.  I downloaded the plugin.  Since I am kind of new to this I have a couple of questions.  Do I need to install the PowerMate software and configure anything for Mach3?

When I press the top of the device it toggles between the available axis but nothing happens when I turn the knob.

Am I missing something?



Offline Hood

  •  25,835 25,835
  • Carnoustie, Scotland
    • View Profile
Re: Griffin PowerMate
« Reply #1 on: December 31, 2007, 03:19:38 AM »
Dont have one so have never looked at the plugin but maybe you have to go into the plugin and set it up? You may find a config page for it from the operator menu.