Is it possible to set up an offset datum that is not on a level plane?
I mean for instance, at X0, mach's z would read 1, and the cutter would indeed be 1 unit from the work surface. then at say x12, mach's z would also read 1, but the cutter would actually be 2 units above the work surface.
Wait a second, suddenly g68 comes to mind as I write this out.
Then I go to the manual and see in 10.7.20, "this only allows rotation when the current plane is X-Y".
And now me thinks this cant be done. right, wrong?
-Nick