Hello Guest it is January 28, 2022, 04:27:26 AM

Author Topic: Offsetting using Plasma post with G41/G42  (Read 1750 times)

0 Members and 1 Guest are viewing this topic.

Offsetting using Plasma post with G41/G42
« on: December 20, 2007, 02:41:26 PM »
I have a dxf that if I bring in and use the mill mode, posts fine.
It outputs the G41 and G42 offsets with the tool chosen.

However, if I try to get it to do this using the plasma mode, I get no G41 or G42s.

It is possible to specify a kerf in the Plasma mode?