Hello Guest it is April 19, 2024, 07:40:21 PM
Profile Guest
« previous next »
Pages: 1   Go Down

Author Topic: Looking for help with determining steps to load into moch 3 mill  (Read 2542 times)

0 Members and 1 Guest are viewing this topic.

Offline gjsrv4

*
  • 3 3
    • View Profile
Looking for help with determining steps to load into moch 3 mill
« on: December 04, 2007, 09:23:38 PM »
I have built a CNC router with half inch lead screws, 10 tpi 2 starts.  I am wondering if someone can help me to figure the number of steps to run moch 3 mill.  I don't know how 2 starts into the formula.  My lead screws are directly connected to the stepping motors which are 200 steps, 1.8 degrees.  Any help would be appreciated.

Glen
Logged

Offline Overloaded

*
  • *
  • 4,922 4,922
    • View Profile
Re: Looking for help with determining steps to load into moch 3 mill
« Reply #1 on: December 05, 2007, 07:12:05 AM »
Hello Glen,
10 tpi / 2 starts = effective pitch of  5
Full step..... 200 x 5 = 1000
Half step.... 400 x 5 = 2000
1/4 step.....800 x 5 = 4000
1/8 step...1600 x 5 = 8000  pulses per unit. (unit = inch)
I hope this helps,
good luck with your project.       8)
« Last Edit: December 05, 2007, 07:14:54 AM by Overloaded »
Logged
Pages: 1   Go Up
« previous next »