Hello Guest it is December 06, 2021, 01:14:47 AM

Author Topic: Arts G100 latest setup PDF  (Read 2703 times)

0 Members and 1 Guest are viewing this topic.

Arts G100 latest setup PDF
« on: December 01, 2007, 05:54:00 PM »
I followed Arts G100 latest setup where it says "6.1.6 Spindle Setup
To set up your spindle to be controlled by an analog output you should only have to do 2
things. Go to Config, Ports and Pins, Spindle Setup and enable ModBus Spindle"

I'm using the PMDX-106 AND I have already tested it and works fine with the Spindle. I have no trouble turning on the spindle on with the Mach3 but I can't control the speed and with the settings exactly as spec out with Mach3. The ground is connected to the ground on the PMDX-106 and the Analog is connected to the Analog in on the PMDX-106. When I increase the spindle speed in mach3 the voltage only increases to +1.8 v at max speed on Analog 4 on the G100 and also the In Mach3 is set to Analog 1 hence the offset in the software. Also the Step light comes on at Axis C Step pin.

Please help!!!!!!!!

Offline Chaoticone

  • *
  •  5,626 5,626
  • Precision Chaos
    • View Profile
Re: Arts G100 latest setup PDF
« Reply #1 on: December 01, 2007, 09:07:33 PM »
I have sent you a personal message. Not because I don't care to share information, but because of time. I'm a little stretched right now.

;D If you could see the things I have in my head, you would be laughing too. ;D

My guard dog is not what you need to worry about!