Hello Guest it is August 22, 2019, 04:39:35 PM

Author Topic: Run From Here  (Read 2229 times)

0 Members and 1 Guest are viewing this topic.

Run From Here
« on: November 20, 2007, 07:19:19 PM »
How exactly does the Run From Here button work in ToolPath view? I've tried it a couple of times but couldn't get the results I was expecting.

Offline Chaoticone

*
  • *
  •  5,573 5,573
  • Precision Chaos
    • View Profile
Re: Run From Here
« Reply #1 on: November 21, 2007, 07:09:09 AM »
You should be able to enter the line number you want to run from, hit run from here, cycle start. You should see a pop up saying mach wants to make a prep move. Accept the move, hit cycle start. It is assuming it has run the code to this point allready so if you were running a roughing pass in the code before the point you started at and you just skipped it by run from herre, that would make a mess.

Hope this helps some,
Brett
;D If you could see the things I have in my head, you would be laughing too. ;D

My guard dog is not what you need to worry about!