Hello Guest it is May 01, 2025, 05:07:05 AM
Profile Guest
« previous next »
Pages: « 1 2   Go Down

Author Topic: Why after RESET the g code back to first line? HELP!  (Read 7436 times)

0 Members and 1 Guest are viewing this topic.

Offline wakedabed

*
  • 106 106
Re: Why after RESET the g code back to first line? HELP!
« Reply #10 on: January 05, 2025, 10:47:29 AM »
I understand you, but how in UC-100 Controller there are not this function or issue! So strange! I think it's a feature in it!
Logged

Offline JohnHaine

*
  • 931 931
Re: Why after RESET the g code back to first line? HELP!
« Reply #11 on: January 05, 2025, 01:37:38 PM »
Better ask over on the CNCDrive forum...
Logged

Offline wakedabed

*
  • 106 106
Re: Why after RESET the g code back to first line? HELP!
« Reply #12 on: January 05, 2025, 01:40:45 PM »
May be you not understand me correct, with UC-100 Controller everything is fine and OK, if I make reset, the g code line do not back to first line, it's ok,,
The problem that I talking about it's happening when I use RNR-MOTION Controller..
Logged
Pages: « 1 2   Go Up
« previous next »