I am trying to operate Mach3 Turn and I am having an issue with it. The Diameter mode vs Radius mode acts as though it is confused. After homing and then touching off;
Diameter Mode, enter command G0 X0 or G1 X0 in MDI:
When I attempt to input the stock coordinates which I identify by skim cuts both Face and turn, I find that the X-axis movement is twice what it should be. In other words it never stops at the center of the chucked stock as it should, it will place the controlled point at exactly the diameter of the stock, 2 times radius.
Radius Mode, enter command G0 X0 or G1 X0 in MDI:
Will make the same move to the far side of the stock but If I attempt to run the job, the controlled point ends up at twice the radius. i.e. a radius of +.500 will position the controlled point to +1"
I have noticed that if I change from Diameter to Radius mode, the axis position according to the DRO is cut in half.
I have no problem with the Z Axis, all dimensions are accurate as expected.
Needless to say I have calibrated and checked the Axis motion and it moves the correct amount. Just not as directed by Mach3 Turn.
My question to you is just to get your thoughts on what might be causing this.
ESS attached to CNC4PC C82 BOB
The plugin I am using is ESS 2019_11_06 10wa-1of1
Windows 10
Mach3 R3.043.062 with Win 10 patch
Dedicated computer, 4 GB memory, Celeron N4120