Hello Guest it is January 19, 2022, 03:09:32 AM

Author Topic: lead in outs  (Read 2951 times)

0 Members and 1 Guest are viewing this topic.

lead in outs
« on: November 07, 2007, 06:53:38 PM »
Lazycam beta does not add G41-G42  to the g-code if I don't add lead in/ out lines or circles. Is it mandatory to allow lead-in /out linesor circles  to get  G41-G42 codes ?

murat. 

Offline Chip

*
  • *
  •  2,055 2,055
  • Gainesville Florida USA
    • View Profile
Re: lead in outs
« Reply #1 on: November 07, 2007, 08:11:20 PM »
Hi, Murat.

I think that is the case, I asked about it some time back, Don't member the reason why it's that way though.

Thanks, Chip
Re: lead in outs
« Reply #2 on: November 10, 2007, 06:50:03 PM »
I thing There is another bug. Lazycam adds G41  or 42 codes  after the line where the  endmill touch the workpiece. Below picture describes what I mean :

Offline PerE

*
  •  16 16
    • View Profile
Re: lead in outs
« Reply #3 on: November 21, 2007, 04:48:15 AM »
Hi.
I have also problem with the G41. Lcam generate some very strange code with small reverse movement over the desired lines so when i cut it cuts over my lines and back again. It is a very simple rektangel.
I will try it more today and coming back with the results but i have been struggling with this for a couple of days now.
Best regards.
Per
Here is the picture from Mach3 2.60
« Last Edit: November 21, 2007, 05:34:40 AM by PerE »