Hi,

I have been using Mach4 for quite some time to control a little 3 axis mill.  I was on build 4517.  Today I updated to the latest build in order to get the plugins to use a wireless pendant for manual control.  All of my settings seem to have ported over correctly, however, now when I go to the Offsets tab to set my work 0,0,0... I cannot change the diameter of the edge finder.  I can click the number and change it, but when I hit enter it just goes back to what it was originally set at.  I backed up my previous Mach4 folder before installing the new one, as is instructed by Artsoft.  If I run the backed up version, I can change the edge finder diameter as I always have.  Am I missing something?  Any help is much appreciated!

Thanks,
Jerry