Hello Guest it is January 25, 2022, 02:43:31 PM

Author Topic: physical feed rate over ride knob  (Read 2511 times)

0 Members and 1 Guest are viewing this topic.

Offline patrick71100

*
  •  14 14
  • HURCO
    • View Profile
physical feed rate over ride knob
« on: November 01, 2007, 10:55:46 PM »
  most missed mach3 feature compared to commercial controls i have run,knob should go to 0 when starting a new program,as most crashes
are in the z axis usually tool offset problem or z value store from previous tool etc,enables operattor to stop motion and glance at z position
to see if it looks correct ,i got in that habbit after smashing a few drills due to sticky buttons on controls not zeroing z when setting tool heights,and also it would be great to have a start and e stop physical momentary? switches for safety,will the galil motion card support these
features                    take care guys patrick