Hello Guest it is April 19, 2024, 06:09:52 AM
Profile Guest
« previous next »
Pages: 1   Go Down

Author Topic: mach4 and wrap gcode  (Read 765 times)

0 Members and 1 Guest are viewing this topic.

Offline edcross

*
  • 38 38
    • View Profile
mach4 and wrap gcode
« on: April 30, 2022, 12:19:59 PM »
 When i load this attached and any wrapping gcode file , Mach 4 latest, just shows' a line on the display ( 4w screen set ) and not the part ??.

    Ed
Logged

Offline edcross

*
  • 38 38
    • View Profile
Re: mach4 and wrap gcode
« Reply #1 on: May 04, 2022, 01:49:27 PM »
 I guess Mach support doesn't look at the forum any more .

    Thanks

      Ed :-[
Logged

Offline Graham Waterworth

*
  • *
  • 2,672 2,672
  • Yorkshire Dales, England
    • View Profile
Re: mach4 and wrap gcode
« Reply #2 on: May 04, 2022, 07:01:50 PM »
My guess would be you need to set the A axis rotation in Config - Control - Tool path

You also have no Y axis start point in the code.

« Last Edit: May 04, 2022, 07:06:10 PM by Graham Waterworth »
Logged
Without engineers the world stops

Offline edcross

*
  • 38 38
    • View Profile
Re: mach4 and wrap gcode
« Reply #3 on: May 05, 2022, 11:27:46 AM »
  This is a rotary project , Y is not used . This file cuts fine , it just does not show up correctly on the Mach 4 screen.

     Ed
Logged

Offline RSL3577

*
  • *
  • 18 18
  • The New Kid On The Block
    • View Profile
Re: mach4 and wrap gcode
« Reply #4 on: May 05, 2022, 03:50:36 PM »

 Be sure to check all the modal states and ensure you are using all GCODE calls that can be found in the appropriate MACH GCODE manual. All of which are found within the DOCS folder in their installation.

If a G code is called and not in the manual... the toolpath won't load
Logged
Pages: 1   Go Up
« previous next »