Howdy everybody!
I recently bought a slightly used plasma route Blaze HD plasma table with 80A cutmaster and THC301 made by texasmicrocircuits. However the computer it came with had a bad hard drive. So I installed a new hard drive and installed mach3. Machine works and cuts but I cannot for the life of me find the install file for the Torch Height Control. ( PR301 )made by texasmicrocircuits. Does anyone have the screenset/install file for THC301?
THC30x.EXE or THC30x.ZIP
Also trying to see if if someone has a post processor set up specifically for using the THC301??