Hi,
Anyone had experience setting up a Porelay8 on Mach3? The user manual is helpful to a point but I have not been able to get it functioning.
What I aim to do is to use the relays to control a pneumatic valve set to look after tool changes, coolant, extension and retracting a touch probe and camera.
I did find this
https://www.youtube.com/watch?v=eFzRodtRJEc&ab_channel=CNCPRINT but it is in German and for Mach4 and there are some major differences between the menus in Mach 3 and 4. It really starts to look different around the 2 minute 13 seconds mark.
Thanks
Splint