Hello Guest it is March 29, 2024, 06:48:56 AM

Author Topic: Mach3 RnR motion card - problem with plasma relay  (Read 8845 times)

0 Members and 1 Guest are viewing this topic.

Re: Mach3 RnR motion card - problem with plasma relay
« Reply #10 on: August 21, 2019, 05:13:12 PM »
Something like this board, but I needed more outputs.  Use the 24 volt version and it will work with the same power supply you use for the controller 24v input.  https://www.ebay.com/itm/5V-12V-24V-4-Channel-Optocoupler-High-Low-Trigger-Relay-Module-Board/183776948137?hash=item2ac9f5afa9:m:mPYQKyFRrlGUmBO9Hb0FcJg
Re: Mach3 RnR motion card - problem with plasma relay
« Reply #11 on: May 15, 2021, 06:28:37 PM »
works without problems, here are my settings ! I hope to help someone who uses 5 volt relay!  :) :)