Hello Guest it is April 20, 2024, 04:19:48 PM

Author Topic: touch Probe  (Read 734 times)

0 Members and 1 Guest are viewing this topic.

touch Probe
« on: April 10, 2021, 02:52:13 PM »
When I do a X axis touch probe  command it touches off then is supposed to retract 1.0625 but it only retracts 1.0593,  its always off the same amount no mater how many times I try it.  Any ideas of where this variance is coming from?

I'm running Mach4 ver. 4612


Re: touch Probe
« Reply #1 on: April 13, 2021, 02:46:02 PM »
Hey message support@machsupport.com and I'll try to give you a hand.
Re: touch Probe
« Reply #2 on: April 13, 2021, 03:47:13 PM »
I managed to get it finally by slowing down the probe feed rate speed from 5 to 1, now I’m only off .0002 and that’s close enough when you’re working with wood.