Hi All,
I'm just curious for the time being if this is possible. I would like to interface Mach 4 to a servo drive which can communicate over Ethernet/IP. The motion control signals will be Step and Direction coming from an Ethernet Smoothstepper, however I can also pull diagnostic information over Ethernet *if* there is a way to form and transmit a generic ethernet packet using LUA in Mach 4.
I did something similar a few years back using the serial port to pull diagnostics out of a servo drive and that actually worked great, now I'd like to repeat the endeavour using a different servo drive and Ethernet/IP.
So the question is: does anyone know of a LUA function or library which supports read/write over Ethernet?
Thanks much,
Mike