Hi All
I have the following problem can anyone Help?
My old computer was working ok with Windows XP but after a crash it is now U.S.
My new computer has Mach 3 installed but it will not drive the cnc controller. I
had an engineer fit a Parrallel card to run the cnc but it will not work. Is it due
to the 64 bit opperating system on the new machine? If that is so will the machine
work if i fit a parralell/usb converter lead?
As you have probably guessed I am a bit confused with this problem. Any help in
pointing me in the right direction would be appreciated?
Best Regards
Roy