Hello Guest it is June 21, 2021, 01:06:45 PM

Author Topic: jogging problems after installing a new/old PC  (Read 82 times)

0 Members and 1 Guest are viewing this topic.

jogging problems after installing a new/old PC
« on: March 17, 2021, 03:41:58 PM »
Hi all,
I have just installed another old XP pc to drive my Denford Orac lathe. I am still on the demo version. After installing the new PC i can only seem to jog with the incremental button lit, and only moves the incremental distance or rapid with the shift button pressed.
Before I could jog with just the JOG button lit and could jog as far as I wanted.
What should I enable/disable to get back normal jog control please.
Mick.

Offline TPS

*
  •  2,178 2,178
    • View Profile
Re: jogging problems after installing a new/old PC
« Reply #1 on: March 18, 2021, 02:07:21 AM »
use the Tab Key and then Switch to continious mode.
anything is possible, just try to do it.
if you find some mistakes, in my bad bavarian english,they are yours.