Hello Guest it is March 28, 2024, 07:03:07 AM

Author Topic: Following error  (Read 1486 times)

0 Members and 1 Guest are viewing this topic.

Following error
« on: February 22, 2021, 09:12:21 PM »
Hi all


I was able to work on my flame/plasma table some this weekend, and I ran into a problem.

I do not know if this is a HiCON problem, or a Mach 4 problem.

When I use either the mpg hand pendant, or write a few lines of Goode using the MDI command, everything moves correctly.   I can get all three axis moving at the same time with zero issues.

When I use sheetcam to generate Gcode, and I run this code. When I get to the line that detects the top of the part with a g31, I start getting following error

“ Error:  following error limit exceeded on Motor 0.  Servo disarmed.

Do you have any ideas?


Thanks

Steve

Offline TPS

*
  •  2,501 2,501
    • View Profile
Re: Following error
« Reply #1 on: February 23, 2021, 02:33:25 AM »
have a look here:

https://www.machsupport.com/forum/index.php?topic=44331.0

sounds like the same Problem.
anything is possible, just try to do it.
if you find some mistakes, in my bad bavarian english,they are yours.