Hello Guest it is November 27, 2021, 09:39:11 PM

Author Topic: M40 / M41 touch probe not working.  (Read 263 times)

0 Members and 1 Guest are viewing this topic.

M40 / M41 touch probe not working.
« on: January 29, 2021, 06:59:03 AM »
Hello everyone, this is my first post here.
I tested the touch probe by writing the data to a text file, but Mach3 stops working after the M40 entry and dont write a text file.
The UNCNC manual states that it is supported. Why not also with mach3?
Thanks.

Offline TPS

*
  •  2,210 2,210
    • View Profile
Re: M40 / M41 touch probe not working.
« Reply #1 on: January 29, 2021, 11:51:47 AM »
check

C:\mach3\macros\your Profile Name

wether ther is a M40.M1s and M41.m1s file.
anything is possible, just try to do it.
if you find some mistakes, in my bad bavarian english,they are yours.
Re: M40 / M41 touch probe not working.
« Reply #2 on: January 29, 2021, 04:59:25 PM »
Hi,
I have used, some years ago now, with Mach3 M40 and M41....and they work. As TPS suggests check to make sure that the
macros code exists in your installation of Mach3.

I have used Mach4 for six years now, and there is an equivalent M40 and M41, and I use them daily as part of my
PCB isolation routing process.

Craig
My wife left with my best friend...
     and I miss him!