Hello Guest it is February 24, 2021, 11:15:49 PM

Author Topic: [Help] One axis screen  (Read 279 times)

0 Members and 1 Guest are viewing this topic.

Re: [Help] One axis screen
« Reply #10 on: January 19, 2021, 09:02:16 AM »
If I copy&paste your g-code (that have 4 entrys) it only shows me 3 in the list, then i check again to press GO and anything is happening, actual length is showing -2.55 and your keypad only shows 1 time :/

Maybe something wrong with my profile?
im opening mach3, load the profile, and then i go to view --> load screen

Offline TPS

*
  •  1,981 1,981
    • View Profile
Re: [Help] One axis screen
« Reply #11 on: January 19, 2021, 09:10:20 AM »
maybe E_stop not reseted, Looks like your machine is not moving at all.
anything is possible, just try to do it.
if you find some mistakes, in my bad bavarian english,they are yours.

Offline TPS

*
  •  1,981 1,981
    • View Profile
Re: [Help] One axis screen
« Reply #12 on: January 19, 2021, 09:11:22 AM »
im opening mach3, load the profile, and then i go to view --> load screen

-use load wizard
-select baldestop

to run my wizard
anything is possible, just try to do it.
if you find some mistakes, in my bad bavarian english,they are yours.
Re: [Help] One axis screen
« Reply #13 on: January 19, 2021, 09:15:51 AM »
Its doing exactly the same...

i will try to record a video and upload here

Offline TPS

*
  •  1,981 1,981
    • View Profile
Re: [Help] One axis screen
« Reply #14 on: January 19, 2021, 09:17:28 AM »
you will have to upload the Video to Youtube, will be to large for here.


try to upload a screenshot of mainscreen (1024.set) and of Config -> Ports&Pins -> Motor Outputs here

« Last Edit: January 19, 2021, 09:19:05 AM by TPS »
anything is possible, just try to do it.
if you find some mistakes, in my bad bavarian english,they are yours.