Hello Guest it is May 24, 2019, 11:40:06 AM

Author Topic: new computer, no movement  (Read 4611 times)

0 Members and 1 Guest are viewing this topic.

Re: new computer, no movement
« Reply #10 on: October 06, 2007, 08:00:45 PM »
woooo there. No actually Ive been using turn for a whole three weeks. well I should say not using turn for a whole three weeks as it has been one problem after another.but today I finaly got it all together and working. I havent played with the direction yet honestly. I did set up my tooltable without that though for my turret toolchanger. but I feel like a tutorial other than the begginers tutorial is a bit overdue for turn. perhaps one day.
 I still havent even messed with radius compensation yet. I know if I took a little time I could figure it out but whos got that. If someone showed me Im sure it would take all of 10 minutes.
wish I could be more help.
Chris

Offline Hood

*
  •  25,816 25,816
  • Carnoustie, Scotland
    • View Profile
Re: new computer, no movement
« Reply #11 on: October 07, 2007, 03:36:24 AM »
No problems, just thought I would save myself some time by asking. I have the offsets set up no problem but the only thing to figure is the Tip direction, hopefully I will get my work finished early enough today and get a bit of messing around with the lathe.

Hood