Hi,
do you have a motor assigned as number 5?
If you have no home switch assigned to an axis which is being homed it will 'home in place', ie not move. An axis will
move only when it is logically connected to a motor number and a home signal for that motor is enabled.
Craig
Hi MR. Craig
This my action
configure --> control --> active motor5 and set motor mapping motor5 on C axis
configure --> Plugins --> ESS V.260 --> Input Signals --> Motor 5 Home set correct pin
I create new button on screen by copy from button
Reffecrence Z and change config and rename to C axis
Then
I try on screen click button Refference C . Result = Good, worked.
Then I try to create script macro ::::
function m108()
local inst = mc.mcGetInstance()
local rc = 0
rc = mc.mcAxisHome(inst, 5)
end
if (mc.mcInEditor() == 1) then
m108()
end
I try type in MDI and click cycle Start Gcode
Result = nothing
When I spam click cycle Start Gcode some time it's running for home!!! . I don't know script for check state , set state , before run it's ?
have any Idea for this my problem ?