I'm finding that 3D roughing code generated by MeshCAM clips the edge of the stock as if the Z axis starts moving too soon. It only occurs in 3D roughing. Mach3 has been working flawlessly for the past 3 months doing 2D and 2 1/2D routing. This is the first time I've used 3D. The errors seem to occur when a single line contains a X and Z move. I've tried turning off Constant Velocity, but is has not changed anything. I've tried slowing down the Z axis, which makes it worse (bigger bite on the edge of the stock) I've tried slowing down the X and Y axis, no joy. I'm hoping that someone else has already solved this before.